Holding Tanks by Cellofoam

All units are manufactured from virgin
Linear Low Density Polyethylene (LLDPE)
resin, which contains Ultra Violet (U.V.)
inhibitors and Carbon Black to protect
against U.V. deterioration. These resins
offer a balance of toughness, rigidity,
environmental stress crack resistance
and low temperature impact performance.
We stock a standard black 16x48x72 -
240 gallon and 20x48x72 - 280 gallon holding tank. Typical tank configuration would be four 3" spin welds, two diagonally on top and one on each end. Placement of spin weld fittings on special order tanks is to customer specifications. We offer a wide variety of special order holding tank sizes, ranging from 56 gal to 450 gal. Natural and custom colors are also available.

All units will exhibit the following ASTM typical test results:
Properties	ASTM	Units	Typical Results
Density	D-1505	b/cc	0.936
Melt Index	D-1238	g/10 min	125
ESCR (100/lgepal, F-50)	D-1693(B)	hours	1000
Tensile Strength, 2”/min	D-638	psi	2,750
Elongation at break	D-638	%	600
Flexural Modulus (1% Secant)	D-790	psi	109,000
Low Temperature Impact	ARM STD-40F	ft-lbs	68
Brittleness Temperature	D-746	deg. C	-90
Heat Distortion Temperature	D-648	deg. C	63

All units will be rotationally molded for a seamless one-piece construction, with a nominal wall thickness
of .300/inch. Resin used in the encasement will exhibit resilience against ice, deterioration from
petroleum products, and is recyclable.